Three Angles

• The 5T triple air bag jack has 3 adjustable angles to meet your different demand.
• It only takes about 3-5 seconds with an internal telescopic stabilizer for the car to rise, which is time-saving.

IN&OUT

• Its’ pure copper interface can effectively prevent rust and corrosion
• When inflated, the jack ride, and vice-verse.
• Valves: Bleed Valve & Relive Valve & Intake Valve (From the left to the right)

Long Service Life

• The airbag jack requires almost no routine maintenance work. When not in use, it is only necessary to place the airbag in a cool and dry environment.

Safety

• Lifting height range : 5.5″-16″ (14CM-40CM)
• It’s long-handle designed for labor-saving . With the thicken rubber pad on the top, it is no damage to chassis and sturdy.

Portable

• The high quality casters make it portable and smooth to roll around that you can save your time.
• No more noise with thickened rubber casters

Quality

• The airbag jack is well constructed of high strength steel. The whole adopts full-covering anti-oxidation spray paint, matte baking paint to prevent rust and corrosion.

Instructions for use

Before lifting your vehicle, please check carefully whether there are sharp objects nearby, as they may hurt the air jack and vehicle
To control the switch in the rod back, to insert the compressed air in the right gas nozzle, and close the left switch.
Open the green valve switch, and when the airbag rises, it can be used.
To fall the jack, please open the red switch.

Weight Capacity :11023 lbs (5 tons)
Lifting height range :5.5″-16.5″ (14CM-42CM)
Working Temp :-60℃~ 50℃
Lifting time : 3sec-5sec.
Working pressure : 145Psi/10Bar/1.0Mpa
Air inlet : G1/4
Type : Long Adjustable Handle Triple Bag Air Jack

Warm Warning

• Always firmly apply parking brake
• Please used in the relatively level, solid ground
• Place the wheel chocks at the front and rear of tires that will not be lifted before proceeding
• Weight must be supported by a set of jack stands rated at the proper capacity before any work or inspection can be done on vehicle.
• Do not exceed the rated capacity or loss of load may occur